Wall Mounting The Gateway - HPE Aruba Networking EdgeConnect 10106 Installation Manual

Wall Mounting the Gateway

The mounting brackets can also be used for wall mounting the EdgeConnect 10106 SD-WAN
Gateway.
Required Tools and Equipment
The following tools and equipment are required for installing the Gateway:
Mounting brackets (x2) (included in the kit)

Screws for mounting bracket (x7): M3 x 8 mm Phillips Flat Head Screws (included in the kit)

Wall anchors

Wall mounting screws

Suitable screwdrivers for all screw types (not included in the kit)

Rubber feet (included in the kit)

Installation Steps
1. Fasten the mounting brackets over the mounting holes on the sides of the Gateway using the
seven screws for mounting brackets (four through one bracket, three through the other) and a
suitable screwdriver.
Orient the mounting brackets as shown in
Figure 23 Attaching the Wall Mount Brackets
2
2. Attach the rubber feet at the designated locations on the bottom side of the Gateway.
3. After you have chosen a mounting location, mark the locations on a wall where you intend to
make the mounting holes.
Ensure that the Ethernet ports are facing down when installing the Gateway on a wall.
4. Create the holes and insert wall anchors if your installation requires them.
5. Align the mounting bracket holes with the holes you created on the wall. See
HPE Aruba Networking EdgeConnect 10106 SD-WAN Gateway
wa n 0/1
mb o)
wa n2 (co
Po E
0
lan bo )
2(c om
lan 1 lan
1
| Installation Guide
Figure 23.
2
10 6
1
EC -10
mg mt 0/1
co ns ole
Figure 24.
Installation | 19