Table of Contents
Advertisement
IMPORTANT - READ THIS FIRST: You must install and register your Orchestrator with the HPE Aruba Networking
Cloud Portal BEFORE setting up an EdgeConnect gateway. After Orchestrator is registered with your account
name and key, you can proceed with EdgeConnect installation. If you don't know or are unsure about
Orchestrator's role, contact your network architect or deployment lead.
Install the Gateway into the Network
All copper RJ-45 Gigabit Ethernet interfaces in the EdgeConnect 10106 Gateway support MDI/MDI-X
and auto-negotiation.
To install the Gateway into the network, perform the following:
1. Identify the relevant ports on the rear of the Gateway.
2. Connect network cables from the Gateway to the identified network equipment ports.
Figure 25 Connecting the Gateway to Network Equipment Ports.
RJ-45
cable
Management Port Connectivity
EdgeConnect 10106 Gateways provide management ports mgmt0 and mgmt1, described in
Table 11 EC-10106 SD-WAN Gateway Management Ports
Management Port
mgmt0
mgmt1
HPE Aruba Networking EdgeConnect 10106 SD-WAN Gateway
lan0/lan1
lan2
wan2
Transceiver
with Fiber
lan0
EC-10106
SD-WAN Gateway
Switch
Factory Default
DHCP
169.254.0.1/16
wan0/wan1
mgmt0/mgmt1
Internet (ISP-1)
wan0
Router / CPE
wan1
MPLS
or
Internet (ISP-2)
Router / CPE
Use Case
A management network exists. Network administration can
provide you the DHCP IP address based on MAC.
Establish management communications with the appliance
by directly attaching a laptop with an RJ-45/CAT5 cable.
| Installation Guide
Chapter 3
Configuring the Gateway
RJ-45
cable
Configuring the Gateway |
Table
11.
21
Advertisement
Table of Contents
