Table of Contents
Advertisement
Installing the Server Board
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. If available, place the EMI gasket over the I/O connectors on the system board.
3. Insert screws through the mounting holes and into the threaded standoffs. Make sure the board
is properly seated, and then tighten all the screws firmly (6.0 inch-pounds).
4. Connect all internal cables to the system board.
5. Reinstall add-in boards.
6. Connect all internal cables to add-in boards. Make sure you connect the power cables to the
correct power connectors.
7. Connect all peripheral device cables to the I/O panel on the rear of the system.
8. Run the SSU to configure the system.
Figure 3. Server Board Screw Hole Locations
OM07056
23
Advertisement
Table of Contents
