Table of Contents
Advertisement
A
9. After you have installed the processor, you must configure its speed.
Replacing the Back-up Battery
The lithium battery on the system board powers the real-time clock (RTC) for up to 10 years in the
absence of power. When the battery starts to weaken, it loses voltage, and the system settings
stored in CMOS RAM in the RTC (for example, the date and time) may be wrong. Contact your
customer service representative or dealer for a list of approved devices.
The following warning and translations are required by specific certifying agencies to be printed
immediately adjacent to the procedure for removing the real-time clock.
WARNING
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the equipment
manufacturer. Discard used batteries according to manufacturer's
instructions.
ADVARSEL!
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning
må kun ske med batteri af samme fabrikat og type. Levér det brugte
batteri tilbage til leverandøren.
Figure 8. Locking in the Processor
A.
Processor latches; must be pushed outward until they click
into retention module
B.
Fan heat sink power cable; must plug into processor fan
connector on system board
C. Processor fan connector
B
C
OM06346
29
Advertisement
Table of Contents
