Vivitek DU6693Z-WH User Manual page 49

DU6693Z DLP Projector - User Manual
Advanced Menu
RS232
Baud Rate: Set the transmission rate to 38400, 19200, 9600. The setting of the transmission rate is dependent on the
length of the RS-232 cable. Low transmission rate is usually set for which transmission distance is long; please select
a suitable transmission rate.
Channel: The RS232 control command can be sent to the projector through its RS-232 port, the command can also be
sent to the projector through the external HDBaseT transmitter to HDBaseT/LAN terminal of the projector. Set the
following communication channels before sending the control command
Local: The RS-232 control command is sent through the RS-232 port on the projector. Select an appropriate
transmission rate.
HDBaseT: Transmission is conducted from the external HDBaseT transmitter to the RJ-45 port on the projector. The
transmission rate is switched to 9600.
Auto Power Off
This function is set to OFF by default. When it is set to ON and no input signal is received within 20 minutes, the projector
will turn off automatically.
Auto Power On
This function is set to OFF by default. When it is set to ON, the projector will turn on automatically when y AC power is
turned on next time. You can use this function and the power switch (instead of the remote control) to turn on the projector.
Set this function to OFF if it's unnecessary.
Message Box
This function allows you to disable the pop-up message at bottom-right of the screen or any reminding message.
Set this option off to disable the message on the screen except of OSD menu.
Screen Format
This function allow you to resize the projected image for fitting the projection screen, the selectable screen format is 16:10,
16:9, 4:3. The projected image is scaled down if the option is set to 16:9 or 4:3, the image can be moved a little bit for
fitting screen by Screen Shift function.
Screen Shift
This function allows you to adjust projected image position if screen format is not set to native aspect ratio. For example,
native aspect ratio of the projector is 16:10, the image can be moved up or down if Screen Format is set to 16:9; the
project ted image can be moved left or right if Screen Format is set to 4:3. The option can't be selected if screen format is
set to native aspect ratio of the product.
H/V Alignment
H Zoom: Use ◄► to narrow the horizontal size of the projected image.
V Zoom: Use ◄► to narrow the vertical size of the projected image.
H Shift: Use ◄► to move the narrowed projected image horizontally. This function is only available when the
projected image is narrowed.
V Shift: Use ◄► to move the narrowed projected image vertically. This function is only available when the projected
image is narrowed.
Reset: Set the H/V Alignment back to the factory default value.
UM66931217EN00
48