Vivitek DU6693Z-WH User Manual page 27

DU6693Z DLP Projector - User Manual
The set ID number is overwritten if new ID number is set, you can press ID SET and CLEAR button to erase ID number of
the remote control
Press ID SET and CLEAR buttons simultaneously
Checking the identification number of the projector and remote control
The identification number of the projector and remote control can be checked by SERVICE menu as below figure,
"X" represents that the function is not enabled; the number 26 is the current identification number of the remote control
Note:
 Project ID Control function is available when the option is turned on and remote control wire is not
plugged into the wire remote jack.
 If ID Control Enable is set to Off, projector can receive any control signal from the remote control even ID
number is set into the remote control.
UM66931217EN00
The backlight of the buttons is flashing one time
26