Vivitek DU6693Z-WH User Manual page 43

DU6693Z DLP Projector - User Manual
Digital Alignment
Select this function to enlarge the projected image.
Digital Zoom: Use ◄ or ► buttons to enlarge the projected image.
Digital Pan: Use ◄ or ► buttons to move the projected image horizontally. This function is only available when the
projected image is enlarged.
Digital Scan: Use ◄ or ► buttons to move the projected image vertically. This function is only available when the
projected image is enlarged.
Reset: Set the Digital Alignment back to the factory default value.
Trigger 1, 2
The projector is provided with a set of trigger output. User can connect the trigger to the screen with projector by the cable.
If user does so, once the projector is powered, the screen would be automatically turned on as well. There is a 2-3 second
delay to activate this function.
Dynamic Black
This is function can be used to enhance the black level of the projected image, set it to on to active the dynamic black
shutter, otherwise, set it to off to disable it.
3D
3D Format: Select this option and press the Enter button to enable 3D replay and set 3D option.
Off: Turn off the 3D Display Mode. When Auto, Side by Side, Top/Bottom or Frame Sequential is selected, the 3D
mode will be turned on. To turn off the 3D Mode, select "Off" and press the Enter button.
Auto: Enable the 3D format to automatically detect the formats of Side by Side, Top/Bottom and Frame
Sequential. This function may only be enabled for the input signal below
- The input signal is HDMI 1.4 3D.
- The HDMI 1.4 3D signal connects to the projector through HDBaseT transmitter.
Side by Side: Manually switch the 3D Format to Side by Side. This option is only applicable to the HDMI input
signal or the signal through a HDBaseT transmitter
Top/Bottom: Manually switch the 3D Format to Top/Bottom. This option is only applicable to the HDMI input
signal or the aforementioned signal sent through the HDBaseT transmitter.
Frame Sequential: Set the format to Frame Sequential.
DLP Link: Set to activate or deactivate the DLP Link sync signal.
Eye Swap: If the 3D imaged viewed through the 3D glasses for the left and right eyes are inverse, set the Eye Swap to
"Reverse". If the images are normal, keep the current.
3D 24Hz Display: Set the 3D 24Hz image frame rate to 144fps or 96fps, this option is only applicable when the input
signal is 24Hz.
Sync Delay: Manually switch the Dark time for glasses tolerance.
Sync Reference: The projector provides DLP Link and 3D IR sync for 3D display; you can specify the built-in DLP Link
or external 3D IR transmitter to synchronize the signal of the 3D glasses. This function is only applied to the condition
that 3D Format is Frame Sequential or external 3D sync device is connected to the projector.
External: Signal is sent from external 3D sync signal receiver.
Internal: Signal is sent by the projector, 3D sync signal is DLP Link.
 The projector provides DLP Link and 3D IR sync. After the 3D Mode is enabled, the built-in DLP Link
or external 3D IR transmitter can be used to synchronize the signal of the 3D glasses. Or, you may
turn off the DLP Link sync signal and only select the external 3D IR transmitter to synchronize the 3D
signal.
UM66931217EN00
42