Vivitek DU6693Z-WH User Manual page 48

DU6693Z DLP Projector - User Manual
 There are two default center positions for UST (Ultra Short Throw) Lens and non-UST Lens, make
sure Lens Type setting is correct before performing this function.
 If Ultra Short Throw Lens is installed, make sure the support kit is detached before performing Center
Lens.
Lens Memory
This projector supports Lens Memory function, Lens shift, Zoom and Focus memory can be stored in the projector up to
10 sets. You can load the stored memory setting to set up the lens automatically, and give a name for the memory set by
keyboard simulator as below figure.
Load Memory: Use▲or▼ to select the desired memory setting then press ENTER button to execute the lens setting, the
projector will adjust the Lens position, Zoom and Focus automatically.
Save Memory: Use ▲or▼ to select the memory set for storing the setting then press ENTER button to confirm.
Clear Memory: Select the memory set to be cleared then press ENTER button to confirm clearing memory set.
Keystone
When the image is projected toward the screen at angle, the image becomes distorted trapezoid; this function can be
used to correct the distortion.
H Keystone: Use ◄► to correct the distortion in horizontal direction.
V Keystone: Use ◄► to correct the distortion in vertical direction.
Reset: Reset H and V keystone to default settings.
Refer to the section" Correcting Keystone Distortion"
Corner Adjustment
Keystone adjust the four corners followed specified ratio at the same time, this function allows you to adjust the individual
corner in horizontal or vertical direction as below illustration
Refer to the section "Correcting Distortion at the Corner"
UM66931217EN00
47