Osd Operation - Installation - Vivitek DU6693Z-WH User Manual

DU6693Z DLP Projector - User Manual

OSD Operation - INSTALLATION

Projection Mode
Use the ◄ or ► buttons to select a projection mode to change the direction of the image. The selectable options are as
follow:
Auto-Front: Turn on the orientation sensor to change automatically the direction of the image.
Desktop Front: Install the projector on the desktop and project the image forward.
Desktop Rear: Install the projector on the desktop and project the image from the rear of the screen.
Ceiling Front: Mount the projector on the ceiling and project the image forward.
Ceiling Rear: Mount the projector on the ceiling and project the image from the rear of the screen.
High Altitude
Use this function when using the projector above an altitude of 1,219 m. The cooling fan needs to be regulated to a higher
speed for better cooling in a high altitude environment. The selectable options are as follow:
Sea Level: When using the projector under 4000ft (1219m).
A1 (4000ft/1219m): When using the projector between 4000ft (1219m) to 8000ft (2438m)..
A2 (8000ft/2438m): When using the projector above 8000ft (2438m).
Standby Mode
Use the ◄ or ► buttons to set up Standby Mode.
Network Standby: The projector maintains in the standby status at higher power (<3W) for network control. In this
mode, the projector can be turned on via network control system.
Eco: The projector maintains in the standby status at the lowest power (<0.5W), the projector can be turned on using
the remote control, RS-232 command.
Remote Sensor
This function allows you to setup the IR control signal receiving from which receiver of the projector.
Front / rear: Both front IR and rear IR receiver are turned on.
Front: Turn on front IR receiver only; rear IR receiver is turned off.
Rear: Turn on rear IR receiver only; front IR receiver is turned off.
HDBaseT: Select HDBaseT input for IR control signal transmitting if the optional HDBaseT transmitter is capable of IR
signal receiving and transmitting. Both front IR receiver and back IR receiver are turned off if the option is selected.
Off: Turn off all of receivers.
 All of IR signal receiving is disabled when the option is selected to Off, the projector can be operated
by control buttons on the projector and RS-232 command only.
UM66931217EN00
44