Step 7, Adjust Door Swing Wees - Monogram ZIS360N Installation Instructions Manual

Installation Instructions
STEP 5| LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
¢ To level the back of the refrigerator, turn the
7/16" hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower the
refrigerator.
¢ For front leveling, use a 1-1/4" open-end wrench.
¢ Adjust height of refrigerator to match installation
cutout opening 83-1/2" to 84-1/2". The refrigerator
should be level and plumb with cabinetry.
Hex Nut Adjusts
Rear Wheels
) Leveling Leg
CAUTION:
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1". If the
installation requires more than 84-1/2" height, the
installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator
more than 1", you will damage the front leveling
legs and the rear leveling wheels.
PRUDENCE
Les roues de nivellement arriére et les pattes de
nivellement avant permettent un réglage maximal
de 25 mm (1 po). Si Pouverture pour le réfrigérateur
aune hauteur supérieure a 2,15 m (84-1/2 po),
Pinstallateur doit élever le réfrigérateur sur une
feuille de contre-plaqué ou des glissiéres. II est
également possible d'ajouter des baguettes de
finition des placards sur le haut de ouverture afin
de la réduire. Lever le réfrigérateur de plus de 25
mum (1 po) endommage les pattes de nivellement
avant et les roues de nivellement arriére.
13
STEP 6} SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step for anti-tip
security, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
¢ Raise the grille panel to access case trim.
¢ Drill hole in trim and drive screw through the trim
into adjacent cabinet.
¢ Follow the same procedure on the opposite side.
Raise Grille Panel
to Stop Position
\
Through Case Trim Into
Adjacent Cabinets
STEP 7} ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
Interior
¢ Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is factory installed
in the 130° position.
¢ Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90° position.