Led Indications; All Units Status Led - Siemens Simcenter SCADAS RS User Manual

LED indications

LEDs on the front of the units indicate the different states with different colors. The LED can either be ON
or OFF in a certain color or blink in a certain color with a certain blink rate. The colors and blink rates in
principle are identical for ALL units. Not all units may show them, depending on the type of unit.
In case a LED needs to represent more than one piece of information with the same priority, information
of individual channels will take priority over information of the unit.
Blinking type and meaning
Solid (steady state)
Fast (waiting)
Normal (transient)
Slow (sleep)

All Units status LED

LEDs on the front of all units provide information by means of blinking frequency (see table above) and
color. The status LED of ALL units is in the same location on the front of the units.
General Unit status LED states
Booting and Initializing
Upgrading firmware
Identification (via GUI)
Internal Error / Unexpected Error
Idle state
*) 5 s default, user editable.
User Manual Simcenter SCADAS RS system, Simcenter Testlab
© 2023 Siemens
Blinking timing loop
Attention!
For more detailed information on LED indications and unit states, consult the
software application.
0 s . . . . . . . . . . . . . . . . . . 1 s . . . . . . . . . . . . . . . . . . . 2 s
LED indications
Blinking Color
Normal White
Normal Cyan
Fast Magenta *)
Solid Red
Slow Green
12-9