8. Mounting and combining units
Attention!
Use stainless steel bolts and washers if the units are going to be used in a corrosive
environment.
Caution!
Do not over-tighten the bolts as it can damage the unit. The maximum applied
torque is 6 Nm.
®
Recommended thread-locker when required: Loctite
2400, medium-strength
(refer to the TDS and MSDS for application and safety details).
Caution!
Do not over-tighten the straps to prevent damaging the units.
The straps must have a minimum tensile strength of 500 kg.
8-12
User Manual Simcenter SCADAS RS system, Simcenter Testlab
© 2023 Siemens