Canon MG2100 Series Simplified Service Manual page 5

Error
Error
code
Ink cartridge not [1401] E05 U051 Print head is not
installed.
Ink cartridge [1403] E05 U052 The type of print
temperature
sensor error.
Non-supported [1485] E05 U059 Appropriate ink
ink cartridge is
installed.
Ink cartridge in a [1486] E07 U076 Some ink cartridges
wrong position.
Multiple ink [1487] E07 U075 Some ink cartridges
cartridges of the
same color
installed.
Ink cartridge [1682] E15 U150 The following ink
hardware error
Ink cartridge [1684] E14 U140 The following ink
region code is
wrong.
The remaining [1686] E13 U162 The ink may have
ink amount
unknown.
Ink cartridge not [1687] E04 U053 The following ink
completely
installed.
No ink (BK). [1688] E16 U163 The ink has run out.
Warning: The
ink absorber
becomes almost
full.
- Main (Black) [1702]
[1703]
- Main (Color) [1704]
[1705]
- Platen (home [1712]
position) [1713]
- Platen (away) [1714]
[1715]
U Message on the
*1
No.*2 LCD*2
installed. Install the
print head.
head is incorrect.
Install the correct
print head.
cartridge is not
installed. Install the
appropriate ink
cartridge.
are not installed in
place.
are not installed in
place.
cartridge cannot be
recognized.
cartridge cannot be
recognized.
run out. Replacing
the ink cartridge is
recommended.
cartridge cannot be
recognized.
Replace the ink
cartridge.
E08 --- The ink absorber is
almost full. Select
[OK] to continue
printing. Contact the
service center for
replacement.
Solution
- Re-set the ink cartridge properly.
- Confirm that the carriage contact
pins are free from any foreign
material, damages, or bending.
- Replace the ink cartridge.
- Replace the applicable ink cartridge,
or press the Stop button for 5 sec. or
longer to continue printing without
replacing the ink cartridge(s).
When the error is cleared by
pressing the Stop button, the
function to detect the remaining ink
amount is disabled.
- Re-set the ink cartridge(s).
- Replace the ink cartridge(s).
- Replace the applicable ink cartridge,
or press the Stop button for 5 sec. or
longer to continue printing without
replacing the ink cartridge(s).
When the error is cleared by
pressing the Stop button, the
function to detect the remaining ink
amount is disabled.
- Replace the ink absorber, and reset
the applicable ink absorber counter.
See 3-2, Main Ink Absorber
Replacement, for details.
Pressing the OK button will exit the
error, and enable printing without
replacing the ink absorber.
However, when the ink absorber
becomes full, no further printing can
be performed unless the applicable
ink absorber is replaced and its
counter is reset.
(5/34)
easyfixs.blogspot.com
Parts that are likely
to be faulty
- Carriage unit