Table of Contents
Advertisement
automatically judges whether the
total colour difference ΔE* is
qualified according to the tolerance
value set by the user during sample
measurement. If the value of the
total colour difference ΔE is less
than the tolerance value, it is
qualified; if it is greater than the
tolerance value, it is not qualified.
10.18 Average
If the sample to be measured is
relatively large or not very uniform, the
average reflectance of multiple points
can be obtained by measuring a large
number of representative test points.
Then the calculated chromaticity data
can better represent the true
chromaticity value of the sample to be
measured, and the device can
perform a 2-99 average
measurement.
Click on Average in the main menu,
where you can set the average
measurement times. Then enter the
average number of measurements
and click on "
" to confirm. If the
average number of entries is 1,
measure in the conventional way; if it
is greater than 1, the measurement
results will be averaged according to
the specified number of
measurements during the standard
and sample measurement.
10.19 Print Setting
The microprinter is not a standard
accessory and must be purchased
separately.
Use a USB printer or a Bluetooth
printer to print out the current
measurement report (some models).
JCS-BA-e-2410
en | 27
Advertisement
Table of Contents
