Adjusting Various Settings; How To Confirm Current Settings; Dip Switch - Epson TM-P60 Technical Reference Manual

2.5 Adjusting Various Settings

This printer is able to be adjusted for the items below:
❏ DIP switch (handshake of serial communication conditions)
❏ Memory switch (serial communication conditions, roll paper width,
❏ Roll paper width (58mm / 60mm)
The current settings can be confirmed by a self test. (See "3.5.1 Self test mode" (page 3-3).)
Note:
When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings
by running a self-test. See "3.5.1 Self test mode" (page 3-3) for detail.

2.5.1 How to Confirm Current Settings

You can use a self-test to confirm the current settings. See "3.5.1 Self test mode" (page 3-3).

2.5.2 DIP switch

This printer has DIP switches 1~4. These are located as shown in the figure below.
1. Make sure the printer is turned off.
2. To access the DIP switches, remove the DIP switch cover by hand (pull out the cover and
then pull it upward to release the projection.)
2-10 Setup
print density, etc...)
Adjusting the spacer and memory switch
DIP switch cover
projection
DIP switch
Rev. D