3. If there is a used roll, remove the core. If you are installing paper for the first time, skip this
step.
4. Install a new paper roll.
Note:
Note the direction that the paper comes off the roll.
5. Pull out the edge of the roll paper within the range "A" on the upper side of the case, as
shown in the illustration above. Then close the cover.
6. The printer feeds the paper to remove slack. When the feeding stops, tear off the fed paper
with the manual cutter.
Rev. F
Roll paper direction
Figure 2-16 Loading paper
TM-J9000/J9100 Technical Reference Guide
A
Setup 2-11