Using Checks In The Non-Asf Model - Epson TM-J9000 Technical Reference Manual

Note:
The driver needs to send a command to eject checks into the pocket and to pull the next check into the
printer.
6. When the entire processing of the checks loaded in the feeder guide is completed, remove
the checks piled up in the pocket.
Note:
Opening the roll paper cover during scanning stops scanning and causes a cut-sheet ejection error. If this
occurs, open the scanner cover, remove the sheet, and then send an error recovery command from the
application.
Opening the carriage cover or scanner cover during scanning returns an error for the image. However,
sending an error recovery command is unnecessary, because the printer does not produce an error.

3.3.2 Using Checks in the Non-ASF Model

To process checks in the non-ASF model checks, insert one check at a time.
1. Make sure the VALIDATION/FEEDER LED is flashing (wait status for check insertion).
Note:
The driver must send the command to start processing to cause the TM-9000/9100 enter the wait
status for check insertion.
2. Make sure the VALIDATION/FEEDER LED is flashing, and insert a check straight with its face
(the side on which MICR characters are printed) facing the front of the printer, continuously
touching the printer with the bottom of the check.
3. When the check slot detects the check, the roller located there starts rotation, and the
VALIDATION/FEEDER LED goes on.
4. When the check is pulled into the printer, immediately let go of the check.
3-6 Operation
➀
✍
Figure 3-4 Inserting a check
Rev. F