Vinotemp WM-1500HZD Service Manual page 23

FRONT VIEW
• Cut a rectangular opening with the ¼" clearance to the width and height of
the cooling unit.
• Screw the exhaust and fresh air grille on the opening from the rear side of
the cellar.
• Mount the gaskets on the four mounting sides.
• Place the cooling unit to a flat and stable place.
• Then move it on the top of the rack temporally.
• Move the cooling unit towards the mounting sides and push to compress
the gasket.
• Locate the 3 brackets (6) and use 7/16" wrench to tighten the 3 screws (7).
• Plug the Winemate cooling unit in receptacle.
• Screw the 2 screws (4) and locate the light on the ceiling.
• Plug the light in receptacle.
• Plug the wine cellar.
Because of potential safety hazards under a certain condition we strongly
recommend against the use of an extension cord. However, if you still select to
use an extension cord, it is absolutely necessary that it is a UL LISTED 3-wire
grounding type appliance extension cord having a 3-blade grounding plug and a
3-slot receptacle that will plug into the appliance. The marked rating of the
extension cord should be 115 V, 15 A. or equivalent and not greater than 15ft in
length.
Figure 4-2
- 22 -
REAR VIEW