Download  Print this page

Vinotemp WM1500HZD Installation Instruction

Vinotemp cooling unit installation instructions
Hide thumbs
   

Advertisement

WM1500HZD & 2500HZD

Installation Instruction

Select a place to mount the unit where the exhaust airflow is unobstructed for a
minimum of 6 inch. The area into which the unit exhausts must be well ventilated.
If it is not, heat exhausted by the unit will build up and the unit will not operate
properly. Additionally, cold air from the front opening must remain unobstructed.
The unit should be mounted near the ceiling and as close to equal distance from
each end of the wall as possible.
Figure 4-1
- 1 -

Advertisement

Table of Contents
loading

  Summary of Contents for Vinotemp WM1500HZD

  • Page 1: Installation Instruction

    WM1500HZD & 2500HZD Installation Instruction Select a place to mount the unit where the exhaust airflow is unobstructed for a minimum of 6 inch. The area into which the unit exhausts must be well ventilated. If it is not, heat exhausted by the unit will build up and the unit will not operate properly.
  • Page 2 FRONT VIEW REAR VIEW Figure 4-2 Make an opening in the wine cellar wall as illustrated in Fig. 4-1. The dimensions of the opening should be ¼ inch larger than the width and height of the unit. Construct a shelf as shown in Fig.4-1. The shelf must be capable of supporting the weight of the unit.

This manual is also suitable for:

Wm2500hzd