Removing Fan Motors; Removing The Start Relay And Overload Protector - Vinotemp WM-1500HZD Service Manual

6. Remove the thermistor from the mounting clip on the front of the
evaporator.

6) Removing Fan Motors

The 4 fan motors are attached to the horizontal fan shroud. The 4 fan motors are
the same and are all powered up at the same time.
1. Unplug the WINEMATE cooling unit or disconnect power.
2. Remove the WINEMATE cooling unit from the enclosure opening.
3. Remover the outer cover.
4. Remove the large styrofoam cover.
5. Disconnect the two wires going to the electrical junction block.
6. Remove the four screws holding the fan to the shroud.
7) Removing the
Start Relay
and Overload
Protector
Figure 2-9
Figure 2-10
- 10 -