Start Automatic Mode; During Operation - Wilo Control EC-Booster Installation And Operating Instructions Manual

8.4

Start automatic mode

8.5

During operation

Installation and operating instructions • Wilo-Control EC/ECe-Booster • Ed.02/2023-08
- Pump 2: P2 Hand
- Pump 3: P3 Hand
3. Start test run: Press the operating button. Pump runs for the set time (Menu 3.10) and
then switches off again.
4. Check direction of rotation.
⇒ Incorrect direction of rotation: Exchange two phases on the pump connection.
▶ Direction of rotation checked and corrected as necessary. The initial configuration is
complete.
Automatic mode after initial configuration
✓ The switchgear is closed.
✓ Configuration complete.
✓ Direction of rotation correct.
✓ Motor current monitoring set correctly.
1. Start Easy Actions menu: Turn the operating button 180°.
2. Select the pump for automatic mode: Turn the operating button until the menu item is
displayed:
- Pump 1: P1 Auto
- Pump 2: P2 Auto
- Pump 3: P3 Auto
3. Press the operating button.
⇒ Automatic mode is set for the selected pump. Alternatively, setting can be per-
formed in Menu 3.02 to 3.04.
▶ Automatic mode switched on.
Automatic mode after shutdown
✓ The switchgear is closed.
✓ Checked configuration.
✓ Parameter input enabled: Menu 7.01 shows on.
1. Press the operating button for 3 s.
⇒ Menu 1.00 appears.
2. Turn the operating button until menu 3.00 appears
3. Press the operating button.
⇒ Menu 3.01 appears.
4. Press the operating button.
5. Change value to "on".
6. Press the operating button.
⇒ Value saved, pump enabled.
▶ Automatic mode switched on.
Make sure the following points are observed during operation:
• Keep the switchgear closed and secure it against unauthorised opening.
• Switchgear attached in an overflow-proof manner (protection class IP54).
• Not exposed to direct sunlight.
• Ambient temperature: 0 ... 40 °C.
The following items of information are shown on the main screen:
• Pump status:
–
Number of registered pumps
–
Pump activated/deactivated
–
Pump On/Off
• Operation with standby pump
• Control mode
• Actual pressure value
• Active field bus operation
Furthermore, the following information is available via menu 4:
en
43