Wilo Control EC-Booster Installation And Operating Instructions Manual page 33

8.3.3 Menu 5: Basic settings
Fig. 36: Menu 5.01
Fig. 37: Menu 5.02
Fig. 38: Menu 5.03
Fig. 39: Menu 5.11
Fig. 40: Menu 5.14
Fig. 41: Menu 5.15
Installation and operating instructions • Wilo-Control EC/ECe-Booster • Ed.02/2023-08
Menu no. 5.01
Description Control mode
Value range P-c
Factory setting Constant pressure control (p-c)
Menu no. 5.02
Description Number of connected pumps
Value range 1 ... 3
Factory setting 3
Menu no. 5.03
Description Standby pump
Value range on, off
Factory setting off
Explanation One pump can be used as a standby pump. This pump is not
activated during normal operation. The standby pump is only
activated in the event of pump failure due to a fault. The
standby pump is subject to standstill monitoring. The standby
pump is therefore activated during pump cycling and pump
kick.
•
•
Menu no. 5.11
Description Pressure sensor measurement range
Value range 1 to 25 bar
Factory setting 16 bar
Menu no. 5.14
Description PID controller: Proportional factor
Value range 0.1 to 100
Factory setting 5.0
Menu no. 5.15
Description PID controller: Integral factor
Value range 0 to 300
Factory setting 2.0
on = Standby pump activated
off = Standby pump deactivated
en
33