Pickering 65-218 User Manual page 8

CAUTION - PRODUCT DOCUMENTATION
Suitably qualified & trained users should ensure that the accompanying documentation is fully read
and understood before attempting to install or operate the product.
SAFETY INSTRUCTIONS
All cleaning and servicing requires the equipment to be isolated and disconnected from the power source and user I/O
signals (refer to the Maintenance Section).
• Appropriate manual handling procedures should be followed as dictated by the weight of the individual module or
the combined weight of the modules & chassis.
• Should a fault occur with the module or chassis, immediately isolate and disconnect the incoming power to the
chassis and the user I/O signals.
• Ensure the equipment is installed, operated and maintained by trained and authorised personnel.
• For suitably equipped products in the event of an emergency press the red "emergency stop" button situated on
the front of the unit.
If it is required to fit this unit into a 19 inch rack, its weight must be
supported by side brackets, runners or a suitable equipment shelf.
The fixing holes in the front panel flanges are designed only for
securing the device in the rack and must NOT be used to support
Please refer to Appendix A for the procedure for fitting the
supplied flanges to either side of the front panel.
THIS UNIT IS CAPABLE OF SWITCHING VOLTAGES AND CURRENTS THAT CAN
CAUSE SERIOUS INJURIES. IN APPLICATIONS INVOLVING HIGH VOLTAGES IT
IS STRONGLY RECOMMENDED THAT UNUSED CONNECTORS ARE CAPPED
TO PREVENT ACCIDENTAL CONTACT WHILE IN USE. SYSTEM INTEGRATORS
AND USERS SHOULD CONNECT TO THE FRONT PANEL CONNECTORS WITH
CONNECTORS OR CABLE ASSEMBLIES THAT ENSURE OPERATORS WILL NOT
INADVERTENTLY COME IN CONTACT WITH HIGH VOLTAGES.
Page viii
Page viii
SAFETY INSTRUCTIONS
WARNING - RACK MOUNTING
the weight of the whole device.
HIGH VOLTAGE SAFETY WARNING
LXI HIGH VOLTAGE 2-POLE MATRIX 60-310
LXI MODULAR HIGH VOLTAGE MATRIX 65-218
!
pickering
pickering
SYMBOL
!