Compact Blender And Juice Extractor Troubleshooting - Cuisinart BJC-550C Instruction And Recipe Booklet

COMPACT BLENDER TROUBLESHOOTING
Problem:
Be sure the blade assembly is on the
blending cup correctly and locked into place
My blender is not Plug the blender into an independent and electrical outlet
turning on and make sure the blender is securely plugged in. If it still
doesn't work, try plugging into a different outlet and/or
check your home's circuit breaker.
The motor could have overheated.
The resettable fuse, which protects the motor if over-
loaded, may have been tripped. When this happens, reset
The blender stops the appliance by unplugging it and letting it cool for a
running minimum of 15 minutes. Then, reduce the contents
of the blending cup and/or clear any jams.
Restart the unit as noted in the operating
directions.
The blade assembly The ingredients cause pressure, and with the airtight
is hard to remove seal, pressure builds up creating a vacuum or
after blending a suction effect. This is normal.
Check rubber gasket and make sure it's flush with the
Unit appears blender assembly. You can also check the rubber gasket
to be leaking to see if is in place or even damaged. The blade assem-
bly should be tight.
Solution:
COMPACT JUICE EXTRACTOR
TROUBLESHOOTING
Problem:
Check to see if the locking clamps are
Juice extractor does properly engaged.
not turn on (See Assembly Instructions, page 6.)
Turn to HIGH to start juicing.
The motor could have overheated.
The resettable fuse, which protects the motor if
overloaded, may have been tripped.
The juice extractor
When this happens, reset the appliance by unplugging
stops running
it and letting it cool for a minimum of 15 minutes. Then,
reduce the contents or clear any jams. Restart the unit
as noted in the operating directions.
Excess pulp in mesh filter basket can slow juice rate.
Juice flow is slow
Stop the juice extractor and clean filter basket.
Difficulty getting herbs Place herbs between other ingredients. When using leafy
or leafy greens down greens, always place the leafy side in first and do not
the feed tube over pack the feed tube.
Unit is on but juice/ Make sure the mesh filter basket/blade
pulp not flowing is in place.
8
Solution: