Sony HD Trinitron HDM-20E1J Operation Manual page 63

This manual explains the location and function of parts
and controls using the control panel of the HDM-
14E5U. The explanation applies to HDM-14E1U/
20E1U with the BKM-10R/11R monitor control unit.
1 Tally lamp
With factory settings, the Tally lamp lights when pins
No. 8 and No. 9 of the REMOTE 2 connector on the
rear panel are shorted. By changing the setting in the
REMOTE menu, different pins on the remote
connector can be used to control the tally lamp.
For information about the REMOTE menu, see "Assigning
the Remote Control Functions (SET UP 2) —REMOTE
Menu" on page 31 (E).
2 POWER switch
Press to turn on/off the monitor. By setting with the
ADDRESS menu, it is possible to turn on/off the
power of the specified monitors only, or of all
monitors at the same time.
For information about the ADDRESS menu, see "Selecting
the Monitor to Control - ADDRESS Menu" on page 45(E).
3 DEGAUSS button
Press to degauss the CRT (every time the monitor is
turned on, the CRT is degaussed automatically). To
degauss again, wait for more than five minutes.
4 Numeric keypad
Use to designate the channel number for the input
signal to be monitored, or to enter the setting values
with the menus.
INPUT
1 3
2
4 6
5
7
8 9
Ent
Del 0
Numeric buttons
Ent button: Confirms the
values and characters entered
(ENTER button of the menu
operation buttons 6 has the
same function).
Del button: Deletes the values
and characters entered.
5 MANUAL adjustment buttons and knobs
Each press of one of these buttons turns the button's
green LED on or off. When the corresponding button
is on (lit), it is possible to manually adjust the contrast,
brightness and chroma by turning the corresponding
knobs. They are also used to enter the setting values
with the menus. It is possible to set the preset value for
each adjusting item with the CONTROL PRESET
ADJ menu.
For Information about the CONTROL PRESET ADJ menu,
see "Preset Adjustment of the Picture Level Control Knobs -
CONTROL PRESET ADJ menu" on page 21 (E).
CONTRAST MANUAL
BRIGHT
CHROMA
PHASE
Note
The PHASE button and knob are not used to adjust the
HDM monitor. They are used to adjust other monitor
connected in serial remote connection (such as BVM-
series Monitor).
6 Menu operation buttons
MENU button: Press to display the Menus.
UP MENU
UP/DOWN buttons: Press to select the
ENTER
DOWN
items and setting values.
ENTER button: Press to confirm the items
and values entered (Ent button on the
numeric keypad 4 has the same function).
For more information about menu operation, see "Basic
Menu Operations" on page 18 (E).
CONTRAST button and
knob
BRIGHT button and knob
CHROMA button and knob
PHASE button and knob:
Changes the items and
settings on the menus
7 (E)