Sony HD Trinitron HDM-20E1J Operation Manual page 69

Monitor 1
REMOTE 1
IN
TERMINATE
ON
OFF
OUT
TERMINATE
switch: OFF
Cable with D-sub 9-pin plugs (not supplied)
8 REMOTE 2 connector (female, D-sub 9-pin)
Forms a pararell switch and controls the monitor
externally. The pin assignment and factory setting
function assigned to each pin are given below.
5
9
Pin number Function
1 Set input signal channel 1 (numeric keypad
function)
2 Set input signal channel 2 (numeric keypad
function)
3 Select sync signal (SYNC button function)
4 Set the screen to monochrome, or set for
automatic switching based on the input signal
(MONO MODE button function)
5 Safe area on/off (SAFE AREA button
function)
6, 7 Not connected
8 Tally lamp on/off
9 Ground
Monitor 2
REMOTE 1
IN
TERMINATE
ON
OFF
OUT
TERMINATE
switch: OFF
1
6
All pin function assignments can be changed with the
REMOTE menu.
For information about the REMOTE menu, see "Assigning
the Remote Control Functions (SET UP 2)—REMOTE
Menu" on page 31 (E).
To switch each function between on and off or
between enable and disable, change pin connections in
the following way.
ON or enabled: Short each pin and pin 9 together.
OFF or disabled: Leave each pin open.
9 ISR (Interactive Status Reporting) connector
(female, D-sub 9-pin)
Connect to the ISR system.
!º CONTROL UNIT connector (female, D-sub 9-
pin)
Connects a monitor control unit such as the BKM-10R
using a cable with D-sub 9-pin plugs such as an RCC-
5G (not supplied).
13 (E)