NetCol5000-A050 In-row Air Cooled Smart Cooling
Product
User Manual
Dual Power Supplies
Step 1 Route the external power cables through the cabinet cable hole, and then
respectively connect the cables to the L1, L2, L3, and N of QF1 and QF2 on the
indoor unit.
If there are two power supplies, connect cables to the active power supply QF1
and then the standby power supply QF2.
Figure 4-82 Routing power cables in the dual power supply scenario
Step 2 Connect the PE cables to the ground screws, as shown in
Step 3 Secure the cables on the post of the cabinet with cable ties.
----End
4.9.4 Installing the Outdoor Unit Power Cable
● The outer insulation sheath should be retained when you route a cable through
the waterproof connector.
● Ensure that the phase sequence is correct when connecting cables.
Issue 13 (2023-08-20)
NO TICE
CA UTION
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installation
Figure
4-82.
117