Using The Usb Port; Switching On The On-Board Computer; Switching Off The On-Board Computer; Using The Push Assist System - Bosch Intuvia Translation Of Original Operating Instructions

6.18.4 Using the USB port

Notice
Any moisture penetrating through the USB port
may trigger a short circuit in the on-board
computer.
 Regularly check the position of the rubber
cover on the USB port and adjust it as
necessary.
The USB port can be used to operate external
devices which can be connected using a standard
micro A/micro B USB 2.0 cable.
1 Open the protective flap on the USB port.
2 Replace the protective flap after using the USB
port.

6.18.5 Switching on the on-board computer

 Press the On-Off button (on-board computer)
briefly.
 The electric drive system is switched on.
6.18.6 Switching off the on-board
computer
If the on-board computer is not inserted into its
mount, it will switch off automatically after one
minute to save energy if no button is pressed.
 Press the On-Off button (on-board computer)
briefly.
 The electric drive system is switched off.
MY22B01 - 12_1.0_26.08.2021
All manuals and user guides at all-guides.com

6.18.7 Using the push assist system

CAUTION
!
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the wheels are not in contact with the
ground when the push assist system is used (e.g.
when carrying the pedelec up stairs or when
loading it on a bicycle rack).
 Only use the push assist mode when pushing
the pedelec.
 You must steer the pedelec securely with both
hands when using push assist.
 Allow for enough freedom of movement for the
pedals.
The push assist system helps with pushing the
pedelec. The speed can be a maximum of 6 km/h
in this case.

The tractive power of the push assist and its
speed can be influenced by the selection of gear.
We recommend using first gear for cycling uphill
to protect the drive.

The level of assistance O FF must not be
selected.
1 Press the push assist button briefly.
2 Press and hold the plus button within
3 seconds to switch on the push assist.
3 Release the plus button to shut off the push
assist. The push assist system switches off
automatically as soon as the wheels are
blocked or the speed exceeds 6 km/h.
Operation
125