Charging The Battery; Charging The Dual Battery; Charging Process When Two Batteries Are Used; Charging Process When One Battery Is Used - Bosch Intuvia Translation Of Original Operating Instructions

6.16.4 Charging the battery


The ambient temperature during the charging
process must be within the range from 0 °C to
40 °C.

The battery can remain on the pedelec or can be
removed for charging.

Interrupting the charging process does not
damage the battery.
1 Remove the cable connection cover if
necessary.
2 Connect the mains plug of the charger to a
normal domestic, grounded socket.
Connection data
Notice
 Check that mains voltage! The power source
voltage must match the voltage indicated on
the charger nameplate. Chargers labelled
230 V may be operated at 220 V.
3 Connect the charging cable to the battery's
charging port.
 The charging process starts automatically.
 The battery level indicator shows the charge
level during charging. When the drive system is
switched on, the on-board computer displays
the charging process.
Notice
If an error occurs during the charging process, a
system message is displayed.
 Remove the charger and battery from
operation immediately and follow the
instructions.
 The charging process is complete when the
LEDs on the charge level indicator (battery) go
out.
4 Once charging is complete, disconnect the
battery from the charger.
5 Disconnect the charger from the mains.
MY22B01 - 12_1.0_26.08.2021
All manuals and user guides at all-guides.com
230 V, 50 Hz

6.16.5 Charging the dual battery

Only applies to pedelecs with this equipment
Notice
 Charge the battery via the accessible charging
socket only.
 Never open a sealed charging socket.
Charging via a pre-sealed charging socket can
cause irreparable damage.
6.16.5.1 Charging process when two batteries
are used
 If two batteries are attached to a pedelec,
charge both batteries via the non-sealed
socket.
 The two batteries are charged alternately
during charging. Charging switches
automatically between the two batteries
several times. The charging time is twice as
long.
 The two batteries are discharged alternately
during use.
6.16.5.2 Charging process when one battery is
used
 If only one battery is inserted, only charge the
battery with an accessible charging socket.
 Charge the battery with the sealed charging
socket outside its mount only.
Operation
120