Bosch Intuvia Translation Of Original Operating Instructions page 180

8.5.8.4 Eightpins NGS2 seat post
Only applies to pedelecs with this equipment
Removing the seat post
1 Use a 2.5 mm hex key to turn the height
adjustment 45° anti-clockwise and move to the
"Open position".
Figure 157: Moving height adjustment to the "Open
position"
2 Activate operating lever. Pull seat post
upwards at the same time and remove
completely.
Figure 158: Pulling the seat post out
3 Activate operating lever. Hold Bowden cable
fastener and pull or tilt forwards. Remove outer
sleeve from the seat post remote control.
Figure 159: Removing the cartridge
4 Use a 5 mm to undo Postpin axle and pull out.
Figure 160: Undoing the Postpin axle
MY22B01 - 12_1.0_26.08.2021
All manuals and user guides at all-guides.com
5 Pull cartridge from the piston rod while pushing
Figure 161: Pulling the cartridge out
6 Hold the cartridge with one hand at the height
7 Hold the white actuating slide in the locking
8 Carefully push the Bowden cable upwards with
Figure 162: Detaching the Bowden cable
 Never pull Bowden cable forwards at an angle.
Figure 163: Bowden cable position
the outer sleeve into the frame at the same
time to help.
of the mechanism and pull the Bowden cable
straight down with the other.
mechanism with your thumb.
the other hand and detach it.
Notice
Maintenance
179