Advertisement
7
Finish sliding the cable around the rotor on the back of the autosampler.
Loosen the thumbscrew on the rotor to allow the cable to pass through the
clamp.
8
Position the cable with your fingertip while you rotate the rotor
counterclockwise until about 2 mm of cable extends past the clamp.
9
Hold the cable flat against the rotor and secure the cable by tightening
thumbscrew on the rotor. The thumbscrew should be as tight as possible using
just your fingers.
EAR99 Technology Subject to Restrictions Contained on the Cover Page.
7
Advertisement
