Advertisement
Step 11: Configure the Autosampler Speed
1
Open the ÄSX Dashboard software, then click Configuration to adjust the
configuration of the autosampler.
2
Change the settings for the X/Y and Z speed from 2 to 4. Then change the pump
speed to its maximum value of 100% and click Write to update the firmware.
3
Exit Äutosampler Config.
Step 12: Install the AScript Software
You will need to know:
➢ The serial number of your autosampler (can be found on the back of
the autosampler).
➢ The COM port number of the autosampler. COM 1-3 are serial
connections and USB connections are COM 4 and above. If you use a
USB connection, the USB driver software will automatically assign a
COM port number when you plug in the autosampler for the first time.
1
On the included USB flash drive, select the ÄScript installer file and follow the
installation process through to completion.
EAR99 Technology Subject to Restrictions Contained on the Cover Page.
16
Advertisement
