After Use; Transport; Storage; Disposal - Dräger FPS 7000 RP Instructions For Use Manual

4.7

After use

● Uncouple the closed-circuit breathing apparatus: Press the button and, at
the same time, pull the plug-in coupling out of the front port.
CAUTION
► To prevent damage, do not pull the connector.
Full face mask
1. Push the adjuster buckles of the neck straps forward with your thumb and
loosen the straps (Figure E).
2. Pull the full face mask away from your face and over your head.
Mask/helmetcombination with S-fix adapter
1. Open the chin strap on the helmet.
2. Pull both mask/helmet adapters evenly to the rear, then flip them away from
the helmet.
3. Remove the facepiece.
Mask/helmetcombination with Q-fix adapter
1. Pull both mask/helmet adapters slightly forward and press the press studs
to unlock.
2. Pull both mask/helmet adapters evenly to the rear, then flip them away from
the helmet.
3. Remove the facepiece.
4.7.1 Maintenance work and maintenance intervals
For information on maintenance work and maintenance intervals, refer to
technical manual 9300767 at www.draeger.com/ifu.
5

Transport

Transport facepiece in a carrying box or mask bag.
Instructions for use |
Dräger FPS 7000 RP
6

Storage

FPS 7000
● Loosen the head harness as far as possible.
● Make sure that the facepiece is dry.
● Pack the full face mask in its bag or carrying box.
● Store the full face mask in a dry, dust-free place where it cannot become
deformed.
● Protect from direct sunlight and thermal radiation.
● Storage temperature: -15 °C to +25 °C
● Observe ISO 2230 and national regulations concerning the storage,
maintenance, and cleaning of rubber products.
Dräger rubber products are treated with an agent to protect against premature
ageing which in some cases is visible as a grey-white coating. This coating can
be washed off with a brush and soapy water.
7

Disposal

Dispose of the product in accordance with the applicable rules and regulations.
| en
Transport
15