During Use; After Use; Troubleshooting - Dräger FPS-COM 7000 Instructions For Use Manual

3. If necessary, select the Bluetooth name on the radio and, if
required, enter the activation code (0000).
In factory setting the Bluetooth name corresponds to the serial
number of the insert for the Bluetooth connection. It can be
modified using the optional configuration software.
When the radio and the communication unit were successfully paired,
it is possible to automatically connect both devices the next time they
are switched on. However, this depends on the type of radio which is
used and its configuration. The radio may require some settings to be
made.
3.4

During use

CAUTION
!
When using a communication unit with a radio, make sure
that there is no acoustic feedback from a second radio.
Acoustic feedback may cause hearing damage.
NOTICE
i
i
If the Bluetooth connection is interrupted, the communication
unit will automatically attempt to establish this connection
again until the radio is within range again. The voice amplifier
unit remains functioning during this process.
3.4.1 Establishing readiness for use
1. Put on the full facepiece. Position the earphone over the nomex
hood and below the protective helmet.
2. Switch on both radio and communication unit.
3. Check the functioning of the communication unit: The volume of
spoken words must be amplified.
4. Adjust the volume on the radio if necessary.
5. Check that communication via the radio is working.
Dräger FPS-COM 7000
3.4.2 Interrupting the automatic shutdown sequence
If the communication unit is not in active use, the "AUTO OFF" warning
signal sounds after approx. 4 minutes. If the communication unit does not
receive further audio signals, it switches itself off after another minute has
passed. It then needs to be switched on again.
To interrupt the automatic shut-down, send an audio signal to the

communication unit (e.g. speak into the full facepiece).
3.5

After use

Clean the communication unit (see chap. 5.2 on page 18).

4

Troubleshooting

Fault Cause
General
Communication unit Batteries depleted
cannot be switched
Batteries not inserted
on
correctly
ON/OFF button soiled Clean ON/OFF
No voice amplification Temporary HazMat
mode selected (see
chapter 3.1.6 on
page 13)
Communication unit
configured for HazMat
mode
Troubleshooting
Remedy
Replace batteries.
Insert batteries
according to
markings.
button.
Restart
communication unit
without HazMat
mode.
Change configuration
with PC software.
15