Truma AquaGo basic Operating And Installation Instructions page 19

b) Draining the water system
Tasks outside the RV
• Remove the access door (refer to "Remov-
ing the access door" on page 9).
• Switch OFF the appliance at the POWER
switch.
• Drain the water system and remove the
water inlet filter. To do this, refer to "Drain-
ing the water and cleaning the water inlet
filter" on page 15, Steps 4 to 8.
You must use the water inlet filter
for decalcification (included with the delivery
Fig. 1 – 11a). If you are using an electric anti-
freeze kit, it must be removed and be un-
plugged from the power supply before decal-
cification (see Fig. 11).
Fig. 11
c) Introducing the decalcification agent
Tasks outside the RV
• Irritation of skin and eyes
in case of contact with decalcification
agent. Wear protective gloves, eye protec-
tion and face protection to avoid contact.
• Fill the water inlet filter with 6 AquaGo
decalcification tablets (content of one blis-
ter pack).
Fig.12
• Re-insert the water inlet filter. See Step 9 in
"Draining the water and cleaning the water
inlet filter" on page 15.
• Switch ON the appliance at the POWER
switch.
d) Filling the water system
Tasks within the RV
• Turn on fresh water supply or switch on
water pump
The decalcification tablets dissolve in
water quickly (approx. 10 minutes). So
that the decalcification agent is not rinsed
out, when filling, run the water only as long
as necessary. The decalcification tablets
color the water slightly red.
• Fill the water system.
– Open all water-release points, e.g., hot
water faucets, showers, toilets.
– Once water flows uniformly, the water
system is vented.
– Close the water-release points.
You must bleed the water system thor-
oughly otherwise the circulation pump can-
not circulate the decalcification solution.
6 x
19