Related Manuals for Truma BGA 14
Summary of Contents for Truma BGA 14
- Page 1 Truma UltraRapid Hot Water System LPG and 230 V / 240 V Electric Storage Water Heater Operating instructions Page 4 Installation instructions Page 8 To be kept in the vehicle!
-
Page 2: Table Of Contents
Operating instructions Installation of the water heater ........8 Water connection .............. 9 Filling the Truma UltraRapid HWS with water ...... 4 Installation of the elbow water connectors ......10 Draining the water heater ............. 4 Installation of the drain valve ..........10 Switching on gas operation .......... -
Page 3: General Safety Notes
– open the windows and doors operation of the system that are not original – do not actuate any electrical switches Truma parts and failure to follow the installa- – have the entire system checked by an tion and operating instructions will void the... -
Page 4: Operating Instructions
Draining the water heater Operating instructions If the vehicle is not used during periods of frost, it is es- sential that the Truma UltraRapid HWS be emptied. Always observe the operating instructions prior to starting! The vehicle owner is responsible for correct opera- Disconnect power for water pump (main switch or pump switch). -
Page 5: Red Indicator Lamp "Fault
If you fail to pack it correctly, the warranty shall ty claims will not be accepted if this is ignored. no longer be valid. Only use original Truma UltraRapid HWS - PCB as spare parts! Red indicator lamp “Fault“ Fault finding The red indictor lamp (a) lights up if there is a fault. -
Page 6: Technical Data
Technical data Dimensions Manufacturer Truma Gerätetechnik GmbH & Co. KG P.O. Box 1252 85637 Putzbrunn / Munich Germany Protection type IP21 Water capacity 14 litres Water pressure max. 400 kPa Type of gas LPG (Propane) Test point pressure 2.75 kPa Fig. -
Page 7: Truma Warranty Policy
– The company will only provide service on presentation – Cleaning of the system or cleaning and adjustment of the of proof of purchase, on either the Truma product, or the gas system. This is considered to be a part of normal prod- Caravan / RV / Pleasure Craft in which the Truma product uct maintenance. -
Page 8: Installation Instructions
= F). or the use of spare parts and accessories that are important to the operation of the system that are not original Truma parts Position template on the outside of the wall. The markings (C) and failure to follow the installation and operating instructions must be above the through-holes. -
Page 9: Water Connection
Mount the grille (8). Press the entire cowl assembly onto the vehicle wall and fasten with 6 screws (5). Screw the Truma UltraRapid HWS securely to the floor of the vehicle with at least two shackle plates (9) with the screws provided, B 5.5 x 25, on suitable base (plywood panel, lami-... -
Page 10: Installation Of The Elbow Water Connectors
45º 20 mm The gas inlet connection is a SAE 45° Flare 1/2 - 20UNF type. For connection to 8 mm steel piping Truma povides an adapt- er UNF 1/2 in. x RVS 8, part no. 70020-02700. Fig. 14 In industrial bulk packs the water connections are preinstalled and have to be tightened after the water pipes have been con- nected. -
Page 11: Installation Of The Control Panel
Disconnect device from power supply before starting to work vehicle or the manufacturer, the electrical connection on electrical components. Switching off at the control panel is must be established in accordance with the Truma interface insufficient! descriptions (refer to Electrical connection 230 V ~ / 240 V ~). -
Page 12: Electrical Connection 230 V ~ / 240 V ~ - Option
Electrical connection 230 V ~ / 240 V ~ Accessories – option – Drain valve and water connectors for flexible water hoses All electrical work and permanent wiring must be car- ried out by a qualified person and in accordance with 34020-63900 Hot water connector, 10 mm the standards AS/NZS 3000, AS/NZS 3001 and all local codes... - Page 13 BGA 14 / BGEA 14 LPG (Propane) and 230 V / 240 V Electric Storage Water Heater When ordering spare parts, please always state the serial number and year of manufacture.
-
Page 14: Wiring Diagram
Wiring Diagram... - Page 15 Notes...
- Page 16 In Australia, always notify the Dometic Service Centre if problems are encountered; in other countries the relevant service partners should be contacted (www.truma.com). Having the equipment model and the serial number ready (see type plate) will speed up processing. Dometic Pty Ltd...