Truma AquaGo basic Operating And Installation Instructions page 35

• Screw the gas line's union nut (wrench size
3/4 in. (19 mm)) onto the appliance's gas
connection so it is finger-tight.
Gas valve may be damaged
•
during tightening! Use a second wrench to
counterhold at the square end (wrench size
11/16 in. (18 mm)).
• Use a torque wrench to tighten the union nut
(nominal torque 15 lb-ft (20 Nm)).
• Risk of poisoning and/or
explosion! Improper tightening of the cable
tie could result in gas/exhaust entering the RV.
• Close the cable tie so that the gas pipe
grommet (rear) tightens the gas pipe passa-
ge (see Fig. 30).
A cable tie is provided with the rear in-
stallation gas connection kit.
Top
Rear
Gas supply line
Side Rigid (metal) 3/8 in. pipe
Gas pipe grommet (rear)
Fig. 30
• Only AquaGo basic (without control
panel):
– Close the side hole with the plug.
Fig. 31
• Only AquaGo comfort /
AquaGo comfort plus (with control panel)
–
cable at temperatures above +60 °C.
Do not install the control panel cable
through the rear gas pipe connection. You
must feed the control panel cable through
the hole on the side.
– Slide the side gas pipe grommet on to the
control panel cable (bush points towards
hole). The control panel cable must pro-
trude by about 25 cm.
–
or explosion! Improper tightening of the
cable tie could result in gas/exhaust en-
tering the RV. Close the cable tie so that
the side gas pipe grommet tightens the
control panel cable passage.
– Fix the side gas pipe grommet to the con-
trol panel cable with a cable tie.
Cable tie
– Attach the control panel cable to the con-
trol panel.
– Hook the control panel cable on to the
clip.
Plug
Fig. 32
Damage to the control panel
Risk of poisoning and/
A cable tie is provided with the appli-
ance. You will find it fixed to the gas
valve.
Control unit
Clip
Gas pipe grommet
(side)
Control panel cable
length 25 cm
Connector
35