Truma AquaGo Comfort Quick Start Manual
Hide thumbs
Also See for AquaGo Comfort:
- Operating and installation instructions (140 pages) ,
- Operating instructions manual (44 pages) ,
- Operating and installation instructions (36 pages)
Advertisement
Table of Contents
- 1 Semi – Automatic Decalcification Drain
- 2 Water System – Decalcification – Instructions
- 3 Preparing for Decalcification/Draining the Water System
- 4 Introducing the Decalcification Agent to the Water System
- 5 Starting Decalcification
- 6 Rinsing the Water System
- 7 Filling the Water System
- 8 Interrupting Decalcification
- Download this manual
Truma AquaGo
The Truma AquaGo is simple to decalcify via the standard Easy Drain
Lever maintenance and accessory interface.
Advantage: Water flow and, consequently, efficiency remain at the
same level as a new device.
Due to the design of instant water heaters, their narrow pipe
cross-section tends to calcify relatively quickly, depending on the
water hardness and the flow rate of the water.
Semi – automatic decalcification drain
•
The standard control panel* shows when it is advisable to
decalcify the device (depending on water consumption)
•
The specially developed Truma decalcification tablets
(part number 77300-01), which have been optimized for
material compatibility and effectiveness, are placed in the
filter sieve of the Easy Drain Lever.
•
The control panel guides you through the decalcification
process.
*An external control panel is standard in Truma AquaGo Comfort and
Comfort Plus manufactured from 2016.
NOTE – Decalcification Tablets Material Safety Data available at
https://www.truma.com/downloadcenter/truma_aquago_decalcification
_tablets.pdf
AquaGo – schr – Version JAN-28-2015, Page ‹#›
®
Copyright by Truma Gerätetechnik, Putzbrunn
Typical calcification
build-up
subject to change without notice
After decalcification with
Truma Decalcification
Tablets
Advertisement
Table of Contents
Related Manuals for Truma AquaGo Comfort
Summary of Contents for Truma AquaGo Comfort
- Page 1 ® Truma AquaGo The Truma AquaGo is simple to decalcify via the standard Easy Drain Lever maintenance and accessory interface. Advantage: Water flow and, consequently, efficiency remain at the same level as a new device. Due to the design of instant water heaters, their narrow pipe cross-section tends to calcify relatively quickly, depending on the water hardness and the flow rate of the water.
- Page 2 WARNING – The use of non original Truma AquaGo decalcification tablets (e.g. vinegar) for decalcification can cause chemical reactions and produce hazardous substances that could enter the drinking supply. • Do not mix Truma AquaGo decalcification tablets with other substances to avoid chemical reactions and produce hazardous substances.
- Page 3 Truma AquaGo Introducing the decalcification agent to the water system: • Fill the water inlet filter with (6) Truma AquaGo decalcification tablets (content of one blister pack.) • Re-insert the water inlet filter. • Switch ON the appliance at the POWER switch.
- Page 4 • Decalcification is interrupted after about two seconds. • The status LED 3 on the control panel flashes quickly. • First you must take out the water inlet filter and remove any Truma AquaGo decalcification tablets that it may contain. • Remove inlet filter after draining system.
Need help?
Do you have a question about the AquaGo Comfort and is the answer not in the manual?
Questions and answers