Truma UltraRapid Operating Instructions Manual

Truma UltraRapid Operating Instructions Manual

Lpg and 230 v / 240 v electric storage hot water system

Advertisement

Truma UltraRapid Hot Water System
LPG and 230 V / 240 V Electric Storage Water Heater
Operating instructions
Installation instructions
To be kept in the vehicle!
Page 4
Page 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UltraRapid and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Truma UltraRapid

  • Page 1 Truma UltraRapid Hot Water System LPG and 230 V / 240 V Electric Storage Water Heater Operating instructions Page 4 Installation instructions Page 8 To be kept in the vehicle!
  • Page 2: Table Of Contents

    4 Pressure and Temperature Relief Valve (P&T safety valve) 5 Cowl for combustion air intake and exhaust gas discharge Operating instructions Filling the Truma UltraRapid HWS with water ...... 4 Pressure and Temperature Relief Valve (P&T safety valve) ... 4 Draining the water heater ............. 4 Switching on gas operation ..........
  • Page 3: General Safety Notes

    – have the entire system checked by an expert! Truma parts and failure to follow the installa- tion and operating instructions will void the Repairs may only be carried out by an warranty and release Truma from any liabil- expert.
  • Page 4: Operating Instructions

    400 kPa occurring in the Truma UltraRapid HWS. Tampering with the P&T safety valve will void the warranty. Filling the Truma UltraRapid HWS with water Check that the drain valve (3) and the P&T safety valve (Fig.
  • Page 5: Switching On Gas Operation

    “Fault” during this time, switch off the appliance – wait 10 minutes – and switch on again! – The Truma UltraRapid HWS must be descaled on a regular basis (at least twice a year). Switching off gas operation...
  • Page 6: Fault Finding

    Maximum working water pressure / P&T safety valve setting Check the power supply (operation voltage min. 10.5 V). 500 kPa – 99 °C – 10 kW Check the Truma UltraRapid HWS fuse (refer to maintenance Type of gas “Fuses”). LPG (Propane)
  • Page 7: Truma Warranty Policy

    Clayton Business Park, 1508 Centre Road, Clayton, Victoria, 3168, – Dometic / Truma are not responsible for resultant loss or Australia damage sustained by the purchaser. for 24 months from the date of purchase against any defect –...
  • Page 8: Installation Instructions

    = F). the operation of the system that are not original Truma parts and failure to follow the installation and operating instructions Position template on the outside of the wall. The markings (C) will void the warranty and release Truma from any liability must be above the through-holes.
  • Page 9: Water Connection

    The pressure reducer (10) must be fitted between the drain valve and water pump in accordance with the direction of Screw the Truma UltraRapid HWS securely to the floor of the flow (indicated by arrow). vehicle with at least two shackle plates (9) with the screws provided, B 5.5 x 25, on suitable base (plywood panel, lami-...
  • Page 10: Installation Of The Drain Valve

    Installation of the drain valve Push elbow fitting without aeration valve (13) as far as possible onto the Truma UltraRapid HWS cold water con- Install the drain valve near to the water heater at a place nection tube (lower tube), and push the elbow fitting with which is easily accessible (Fig.
  • Page 11: Gas Connection

    Truma interface descriptions (refer to Electrical connection 230 V ~ / 240 V ~). For connection to 8 mm steel piping Truma povides an adapt- Any modification made to the Truma components pertaining er UNF 1/2 in.
  • Page 12: Electrical Connection 230 V ~ / 240 V ~ - Option

    Connect to the fuse-protected on-board power supply (central In order to operate the element the manufacturer of the electrical system 5 – 10 A) using a 2 x 1.5 mm² cable. vehicle has to supply and install a socket with switch (2-pole separation) which is approved in Australia and earthed. Connect negative line to main ground connection.
  • Page 13 BGA 14 / BGEA 14 LPG (Propane) and 230 V / 240 V Electric Storage Water Heater When ordering spare parts, please always state the serial number and year of manufacture.
  • Page 14: Wiring Diagram

    Wiring Diagram...
  • Page 16 In Australia, always notify the Dometic Service Centre if problems are encountered; in other countries the relevant service partners should be contacted (www.truma.com). Having the equipment model and the serial number ready (see type plate) will speed up processing. Dometic Pty Ltd...

Table of Contents

Save PDF