Truma AquaGo basic Operating Instructions Manual

Truma AquaGo basic Operating Instructions Manual

Lp gas instant water heater

Advertisement

Truma AquaGo™ LP Gas Instant Water Heater
Model:
Truma AquaGo™ basic (DLE60B) *
Truma AquaGo™ comfort (DLE60C) *
Truma AquaGo™ comfort plus (DLE60CP) *
If the information in these instructions is not
followed exactly, a fire or explosion may result,
causing property damage, personal injury, or
death.
– Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Evacuate all persons from the vehicle.
• Shut off the gas supply at the gas container
or source.
• Do not touch any electrical switch, or use
any phone or radio in the vehicle.
• Do not start the vehicle's engine or electric
generator.
• Contact the nearest gas supplier or certified
service technician for repairs.
• If you cannot reach a gas supplier or certi-
fied service technician, contact the nearest
fire department.
• Do not turn on the gas supply until the gas
leak(s) has been repaired.
Installation and service must be performed by
a certified service technician, service agency,
or the gas supplier.
en-US
Operating instructions
Installation instructions
To be kept in the vehicle.
This document is part of the water heater.
Conforms to ANSI Std Z21.10.3
Certified to CSA Std 4.3
4010007
Sales and Service
Truma Corp.
825 East Jackson Blvd.
Elkhart, IN 46516
USA
Toll Free
1-855-558-7862
Fax
1-574-538-2426
info@trumacorp.com
www.truma.net
* Patent Pending
Page 2
Page 16

Advertisement

Table of Contents
loading

Summary of Contents for Truma AquaGo basic

  • Page 1 Truma AquaGo™ LP Gas Instant Water Heater Model: Truma AquaGo™ basic (DLE60B) * Truma AquaGo™ comfort (DLE60C) * * Patent Pending Truma AquaGo™ comfort plus (DLE60CP) * en-US Operating instructions Page 2 If the information in these instructions is not...
  • Page 2: Overview / Designation Of Parts

    Overview / Designation of parts 4 26 LED 1 LED 2 Fig. 1 (Unit Casing/Frame partially omitted) Fig. 2 (rear view of appliance) Legend 14 Cover plate 1 Cold water connection 1/2" NPT 15 Temperature stabilizer 2 Hot water connection 1/2" NPT 16 Water flow sensor 3 Circulation line connection 1/2"...
  • Page 3: Table Of Contents

    Operating Instructions Operating Instructions Any use other than the intended use (see above) is prohibited. How the Truma AquaGo™ instant water heater works .. 5 Examples of prohibited use: Pressure relief valve .............. 6 • Use in a marine environment.
  • Page 4: Consumer Safety Information

    – Never actuate the pressure relief valve serious injury. (Fig. 1 – 4 ) as long as the Truma AquaGo™ instant water heater is still hot. indicates a hazardous situation – Never actuate the Easy Drain Lever which, if not avoided, could result in minor or (Fig.
  • Page 5: Safety Features

    When the Truma AquaGo™ instant water heater Overcurrent protection is switched on, the tap water will be warmed If there is a short circuit in the Truma on-demand: AquaGo™ instant water heater (>10 A), a • A volume-flow sensor in the Truma fuse on the control unit is activated and the AquaGo™...
  • Page 6: Pressure Relief Valve

    • Never actuate the pressure relief valve as Like in a home shower, a comfortable water long as the Truma AquaGo™ instant water temperature at the shower head is reached heater is still hot. by mixing in cold water.
  • Page 7: Access Door

    • The access door can be opened to two dif- ferent positions: Closing the access door – Position  is the maximum opening width for switching the Truma AquaGo™ instant water heater on or off. – Position  is the starting position for re- moving the access door.
  • Page 8: Placing Truma Aquago™ Instant Water Heater In Operation

    Placing Truma AquaGo™ instant Operating procedures water heater in operation Proceed as follows to fill the Truma AquaGo™ instant water heater with water: 1. Close open bypass lines (if present). Danger of over-temperature and toxic ex- 2. Turn on fresh water supply or switch on wa- haust gases! ter pump.
  • Page 9: Operating Modes

    • Both ON positions on the mode switch have 1. Open the access door (refer to “Opening the the same function. Choose your preferred access door” on page 7). position. 2. Switch off the Truma AquaGo™ instant wa- ter heater at mode switch (Fig. 8). Operating Description Model mode AquaGo™...
  • Page 10: Winter Operation

    (AquaGo™ comfort / AquaGo™ comfort plus winterizing fluid models only) The Truma AquaGo™ instant water heater has a built-in thermostat that will start the burner and the circulation pump whenever the temperature • Winterizing the RV with a winterizing fluid in the Truma AquaGo™...
  • Page 11: Aquago™ Technical Data

    TRUMA determines was defective due to a war- inch 15.1 15.5 ranty defect. Costs of diagnosis for a warranty 20.2 defect are borne by TRUMA. Other costs of di- Standard agnosis are not included in this warranty. At the inch 17.7 17.7...
  • Page 12: Maintenance

    TRUMA knew or should have known of the pos- sibility of such losses or damages, (b) claims, demands or actions against the customer by any...
  • Page 13: Decalcifying

    “Closing the access door” on page 7). Decalcifying • Only use approved substances to decalcify the Truma AquaGo™ instant water heater to avoid damage and the voiding of your warranty. Never use vinegar. Call your local AquaGo dealer or service provider or see www.truma.net for more information.
  • Page 14: Troubleshooting

    LP gas tank is empty. Refill/replace the gas tank. The Truma AquaGo™ instant water Switch on the Truma AquaGo™ instant wa- heater is switched off. ter heater according to instructions (refer to “Operating procedures” on page 8). Fresh water supply is turned off.
  • Page 15 This page is intentionally left blank.
  • Page 16: Installation Instructions

    • DO NOT perform a hi-pot test on the Truma AquaGo™ instant water heater unless the Safety behavior and practices electronic ignition system (circuit board) has been disconnected.
  • Page 17: Preparing For Installation

    Preparing the gas connection 2. To install on carpeted area, install The gas line is guided into the Truma AquaGo™ a metal or wood panel under the instant water heater from the side. A hole with Truma AquaGo™...
  • Page 18 In the absence of local codes and regulations, to the operating pressure of the refer to the latest edition of the National Elec- Truma AquaGo™ instant water heater (10.5" – trical Code ANSI/NFPA No. 70. In Canada, the 14" wc (26.2 – 34.9 mbar)).
  • Page 19: Connection Diagrams

    Connection diagrams • The drawings are not intended to describe a complete system. It is up to the certified service technician to determine the necessary components for and configuration of the particular sys- tem being installed (for example an additional surge damper). •...
  • Page 20: Model Aquago™ Comfort Plus

    Model AquaGo™ comfort plus Faucet 1 Faucet 2 Shower Hot Water Outlet Instant Circulation *Bypass kit for winterizing (not scope of supply) Water Heater Line Inlet Maximum Pressure 65 psi (4.5 bar) Cold Water Inlet Inlet Pressure 10.5"–14" wc (26.2–34.9 mbar) LP Gas Supply (Propane only) Drain Line Fig.
  • Page 21: Installing The Truma Aquago™ Instant Water Heater

    8. Check and make sure that there is a tight damage may occur when the appliance is seal. moved when performing service. 9. Fasten the cover plate to the Truma AquaGo™ instant water heater (see Fig. 17): To achive the watertight seal: • Position the cover plate.
  • Page 22: Connecting The Gas Line

    • Make sure that the gas line is centered 10. Connect the hose for cold water (1) at the and tension-free when it enters the grom- bottom of the Truma AquaGo™ instant wa- met so that the gas line will not abrade the ter heater.
  • Page 23: Functional Check

    8). 2. Check the Truma AquaGo™ instant water heater for proper functionality. • A cable tie is provided with the Truma 3. Provide operating and installation instruc- AquaGo™ instant water heater. You will find tions to the vehicle owner.
  • Page 24: Appendix A - Error Codes

    APPENDIX A – Error Codes If the Truma AquaGo™ instant water heater malfunctions LED 2 (refer to “Overview / Designation of parts” on page 2) will blink to indicate the malfunction. There are short and long intervals of blinking. The blinking will repeat every 3 seconds.
  • Page 25: Appendix B - Functional Diagram

    APPENDIX B – Functional Diagram Fig. 21...
  • Page 26: Appendix C - Spare Parts (All Models)

    APPENDIX C – Spare Parts (all models) 35,36 Fig. 22 Item Part no. Component Item Part no. Component Ref. Ref. Flue Duct Assembly Relief Valve Flue Duct gasket – – Air Overheat Switch Upper housing Assembly 77000-90100 Exhaust Pressure Switch Water temperature sensor 77000-90200 Flue Fan Assembly...
  • Page 27: Appendix D - Electrical Connection Diagram

    APPENDIX D – Electrical Connection Diagram Fig. 23...
  • Page 28 In case you encounter any problems, please contact the Truma Service Center at 855-558-7862 or one of our authorized service partners. For details see www.truma.net. Please have the model number and serial number (on water heater’s type plate) handy when you call.

This manual is also suitable for:

Aquago comfortAquago comfort plus

Table of Contents