Bim Setup Menu - Dakota Digital BIM-01-2-HSN2 Quick Start Manual

BIM setup:
BIM menu table:
Menu Options
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
System Selection for Holley module
The BIM-01-2-HLLY must be configured for the correct type of Holley EFI system being used.
•
Hold the switch on the BIM-01-2-HLLY case while turning the key on. The BIM display will show the current
revision code while this is held.
•
Release the switch.
•
The BIM module should display  (System). Press and hold to enter this menu.
•
When you see "" on the display release the switch.
•
The display will show the current system , , or 
•
Tap the switch to change the system.
 – Standard = Dominator or Terminator HP
o
 – Sniper
o
 – Terminator X only
o
•
To save setting press and hold the switch until you see "" on the display, then release the switch.
• The display will show "". Press and hold the switch to exit setup or tap to choose another menu option.
Enable or disable ability to read speed (HP and Dominator  = )
Not an option when  is set to  or 
With the configuration of the speed input in either the Dominator or Terminator HP, the BIM-01-2-HLLY has the option
•
Hold the switch on the BIM-01-2-HLLY case while turning the key on. The BIM display will show the current
revision code while this is held.
•
Release the switch.
•
Tap the switch until the display shows  (input). Press and hold to enter this menu.
•
When you see "" on the display release the switch.
•
The display will show the current state or the speed input  (enable) or  (disable).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see "" on the display, then release the switch.
• The display will show . Press and hold the switch to exit setup or tap to choose another menu option.
Default
 
For Terminator HP and Dominator systems
 
For Sniper EFI
 
For Terminator X and Terminator X Max
 
  Input 1 speed enable, only in menu when  is set to  (HP & Dominator)
 
 
 
For a handheld display connection to the Holley ECU.
   (handheld connected) or  (handheld not connected).
 
 
Gauge will display MAP/vacuum reading *** Terminator X cannot read MAP
 
Gauge will display boost
 
 
Update communications with other BIM modules attached
 
 
Exit Setup.
 
[7]
Notes
MAN #650832