Advertisement
Table of Contents
Sniper EFI system setup:
Data that should be available: RPM, Engine temp, Intake/manifold temp, MAP/boost, A/F ratio.
Holley system setup: No configuration within the Sniper EFI system or software is required.
BIM-01-2-HLLY setup: The BIM must be configured to understand it will be talking to the Sniper EFI
•
Hold button on BIM-01-2-HLLY and turn ignition on, then release the button.
•
The BIM module should display (System).
•
Hold button until a dash (-) is displayed, and then release.
•
Tap the button to display (Sniper)
•
Hold button until a dash (-) is displayed, and then release.
•
Tap button to display , then hold to save.
Note: Speed Input is not a selectable menu option with selection - Sniper does not send speed.
[2]
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 9
Page 10
MAN #650832
Advertisement
