Advertisement
Display Setup
VFD and VHX systems will add extra readings to the message displays under the tach.
HDX and RTX need a group screen configured to show additional information such as Boost or Intake temp
Setting up the display system will configure the instrument control box to read each input from either the terminals or
through the BIM cable from the Bus Interface Module.
The BIM menu of the display will not find the BIM-01-2-HLLY, but will find specific channels for Fuel Pressure and Air/Fuel
Ratio.
There is no Check Engine option for the BIM-01-2-HLLY to pick up.
The following settings are for the basic information to be displayed with data from the BIM module.
Extra data that might be sent such as Intake Air Temp, Fuel Pressure, Air/Fuel Ratio or Boost, can be brought up in the
message centers of the VFD3 and VHX system by toggling SW2 in normal operation of the vehicle. Similar data that
might be present will not automatically be shown in the HDX and RTX systems. That extra information must be placed in
a group screen of your choice, in the HDX and RTX setup.
Display data usage
The following readings can each be used in place of dedicated sending units to the instrument system control box. These
are individually selectable in the display system instrument setup menus.
VFD3, and VFD3X setup:
**Only VFD3/3X systems with a plastic case, support adding BIMs**
Entering the VFD3 setup is done by holding SW1 (I) and turning the ignition to "on", or "acc".
Once in setup, one can move between speed, tach, volt, water, etc.... by tapping SW1 (I)
If you are setting multiple items, once done with one section you will automatically move onto the next item.
Obtaining RPM from the BIM-01-2-HLLY
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until and TACH are displayed.
•
Press and hold SW1 for at least 3 seconds, until changes to "-". The displays should show and T CAL.
•
Press and hold SW1 for at least 3 seconds, until changes to "-". The speed display will show the current
setting.
•
Tap SW1 until and T CAL are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
Obtaining engine temperature from the BIM-01-2-HLLY
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until and WATER are displayed.
•
Press and hold SW1 for at least 3 seconds, until changes to "-". The displays should show and SENDER.
•
Press and hold SW1 for at least 3 seconds, until changes to "-". The speed display will show the current
setting.
•
Tap SW1 until and BUS F (Fahrenheit) is displayed.
Tap SW1 once more for and BUS C (Celsius) if desired.
o
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
[3]
MAN #650832
Advertisement
