Table of Contents
Advertisement
etting warning levels on a VFD3 or VFD3X system:
S
1. Press and hold SW1 while turning the key on.
a. The message display will show SETUP while speed display will show .
2. Release SW1 (I) to display SPEED and
3. Tap SW1 (I) several times to display BIM and
4. Press and hold SW1 (I) when BIM and are displayed.
5. Keep holding to display SCAN X and -.
a. X = the number of BIM channels found, 4 will be displayed for only a BIM-22-3.
6. Release the SW1 (I) to display SCAN and
7. Tap SW1 (I) once, to display SETUP and .
8. Press and hold SW1 (I) to display SETUP and -.
9. Releasing SW1 (I) will display LF TIRE and
a. The BIM-22-3 module will flash . It is not a problem during setup.
b. Each tire will have a different channel RF=C4, LF=C5, and RR=C6.
c. If a BIM-04-2 is connected, the displays will show TEMP and C1.
d. If a BIM-04-2 is connected, tap SW1 (I) once to change it to LF TIRE and C3.
10. Press and hold SW1 (I) until LABEL and – are displayed.
11. Release to display LF TIRE and .
12. Press and hold SW1 (I) to display WARN and -. A second message center will display LF TIRE.
13. Release to display L 25* and . A second message will display LF TIRE.
a. L represents low pressure and the number is the PSI. 25 is the factory default.
b. A single message center will alternate between L 25 and LF TIRE.
14. Tap SW1 (I) to increment the low-pressure warning point.
a. If 25 PSI is fine, then hold SW1 (I) until L 25 and are displayed.
b. The low-pressure range is 05 to 99 PSI.
c. If you tap past your desired PSI, you must tap up 99 before it restarts at 05 PSI.
15. Press and hold to save the low-pressure warning and L XX (XX=PSI value) and – are displayed.
16. Release SW1 (I) to display H 35* and are displayed. A second message center will display LF TIRE.
a. H represents high pressure and the number is the PSI. 35 is the factory default.
b. A single message center will alternate between H 35 and LF TIRE.
17. Tap SW1 (I) to increment the high-pressure warning point.
a. If 35 PSI is fine, then hold SW1 (I) until H 35 and – are displayed.
b. The low-pressure range is 05 to 99 PSI.
c. If you tap past your desired PSI, you must tap up 99 before it restarts at 05 PSI.
18. Press and hold to save the high-pressure warning and H XX (XX=PSI value) and – are displayed.
19. Release to display SKIP and
a. To do the Locate process see the next page.
20. Press and hold SW1 (I) to skip past the Location process, SKIP and – will display.
21. Release SW1 (I) to display DONE and .
a. To change warnings more warnings, tap SW1 (I) to display another tire and repeat steps 6 to 21.
22. To exit: when DONE and are displayed, press and hold SW1 (I) until DONE and are displayed.
[7]
MAN #650793
Advertisement
Table of Contents
Troubleshooting
