Problems And Warning Signals - ELNA eXcellence 782 Instruction Book

Problems and Warning Signals

If a buzzer sounds and the visual touch screen shows a warning sign, follow the guidance below.
Warning Sign
The start/stop button is pressed with the foot control
connected.
The foot control is broken.
The bobbin winder spindle is shifted to the right.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
The twin needle key is pressed when the twin needle
sign is indicated on the visual touch screen.
The stitch that requires lowering the feed dogs is
selected.
The machine is started with the feed dogs lowered.
The needle plate is removed.
The machine stops due to overload.
Cause
149
Try this
Disconnect the foot control.
Contact the service center
or the store from whom the
machine was purchased.
Shift the bobbin winder
spindle to the left for
stitching (refer to page 21).
Lower the buttonhole lever
and start the machine again
(refer to page 58).
Replace the twin needle
with a single needle and
press the OK key (refer to
page 27).
Lower the feed dogs (refer
to page 33).
Raise the feed dogs unless
you want to sew with the
feed dogs lowered (refer to
page 33).
Attach the needle plate
(refer to page 32).
Check if the needle plate is
attached properly.
Wait for at least 15 seconds
to restart. Remove tangled
threads around take-up lever,
hook race and auto thread
cutter device.