Foot Control And Thread Cutter Switch; Adjusting The Thread Cutter Switch Position - ELNA eXcellence 782 Instruction Book

(1)
(3)
(4)
(4)
1.
(1)
(1)
2.
3.
(3)
(2)
(2)
(6)
(5)
(3)
(2)
(1)
(1)

Foot Control and Thread Cutter Switch

To attach the foot control and the thread cutter switch
to the base plate, tighten setscrews, and setscrews with
washers as shown.
(1) Foot control
(2) Thread cutter switch
(3) Base plate
(4) Setscrew A
(5) Setscrew B
(6) Washer

Adjusting the Thread Cutter Switch Position

Placing the thread cutter switch to the left.
The thread cutter switch position can be adjusted for your
convenience.
If you wish to attach the thread cutter switch to the left
side of the foot control, follow the procedure below.
NOTE:
A Phillips head screwdriver is not included with this
machine.
1. Remove the setscrews A, B and washers with a
Phillips head screwdriver.
(1) Setscrew A
(2) Setscrew B
(3) Washer
2. Turn the base plate 180 degrees.
3. Attach the foot control and thread cutter switch
with the setscrews and the washers. Tighten the
setscrews A and B. Be sure that the cable is not
caught between the foot control and the base plate.
(1) Setscrew A
(2) Setscrew B
(3) Washer
10