Table of Contents
Advertisement
1.
(2)
2.
3.
Corded Buttonhole
To sew a corded buttonhole, follow the same procedure
as for B1 sensor (square) buttonhole.
Select pattern B1.
1. Place the button on the button holder on the
buttonhole foot.
Hook a filler cord on the spur on the front of the foot.
Bring the ends of cord toward the back and under the
foot.
Bring up the ends of the cord and insert both ends
between the ribs and metal plate.
(1) Spur
(2) Metal plate
Set the stabilizer plate as necessary and attach the
buttonhole foot.
(1)
2. Lower the needle into the fabric where the buttonhole
will start.
Lower the foot and buttonhole lever.
Pull the needle thread lightly to the left.
Start the machine to sew the buttonhole over the
cord.
The machine stops automatically when finished.
Remove the fabric from the machine and cut the
sewing threads only.
3. Cut the filler cord at both ends as close to the
buttonhole as possible.
NOTE:
• Do not adjust the opening width wider than 0.8.
• Set the stitch width in accordance with the thickness
of the cord used.
• To cut the buttonhole opening, refer to the
instructions on page 59.
Specialty Stitches
B12 Button Sewing
Refer to page 120 for sewing instructions.
67
Advertisement
Table of Contents
