GETTING READY TO SEW
Connecting the Power Supply
Using the foot control
Turn off the power switch.
Pull the foot control cord from the foot control.
Insert the pin connector into the jack.
Insert the machine plug into the power inlet.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power switch
w Pin connector
r Machine plug
t Power inlet
y Power supply plug
u Wall outlet
The foot control sign will be displayed when the foot
control is connected to the machine.
i Foot control sign
Do not pull the cord of foot control beyond the red
marker on the cord.
The machine will be initialized when turning on the
power switch. Do not touch the machine while the
machine is being initialized.
While in operation, always keep your eyes on the
sewing area and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
Before Using Your Sewing Machine
Before using your sewing machine for the first time,
place a scrap of fabric under the presser foot and run the
machine without thread for a few minutes. Wipe away any
oil which may appear.
The symbol "O" on the switch indicates the "off" position
of the switch.
Foot control model 21371, YC-485-EC-1 or 4C-339JM is
used with this sewing machine.
For the U.S.A and Canada only:
For appliances with a polarized plug (one blade wider
than the other): To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way.
If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not modify the plug in any