ELNA eXcellence 782 Instruction Book page 13

1.
2.
1. 2.
(5)
(4)
(2)
(1)
(2)
(1)
(6)
Adjusting the horizontal position of the thread cutter
switch
1. Loosen the setscrews under the switch.
(1) Setscrew
(2) Washer
2. Slide the switch to the left or right, and fix it at the
desired position by tightening the setscrews with a
screwdriver.
Adjusting the vertical position of the thread cutter
switch
1. Remove the setscrews and washers.
2. Move the switch forward or backward, attach the
switch at the desired position and fix it with the
(3)
setscrews and washers.
(1) Setscrew
(2) Washer
(3) Desired position
NOTE:
• To fix the thread cutter switch at its lowest position,
fix the setscrews into the hole (4), and then holes (5).
• Tighten the setscrews securely.
• Peel off the backing paper from the rubber sole (6)
and attach it to the bottom of the thread cutter switch
as shown.
11