Machine Operating Buttons - ELNA eXcellence 782 Instruction Book

(3)
(7)
(2)
(1)

Machine Operating Buttons

(1) Start/stop button
Press this button to start or stop the machine.
The machine starts running slowly for the first few
stitches, then runs at the speed set by the speed control
slider. The machine runs slowly as long as this button is
pressed.
The button will turn red when the machine is running, and
blue when it has been stopped.
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
the button is released.
NOTE:
• The start/stop button cannot be used when the foot
control is connected to the machine.
• You can select the desired start-up speed from slow,
medium or high (refer to page 143).
(2) Reverse button
• When the following stitch patterns are selected:
Utility Applique
The machine will sew in reverse as long as the reverse
button is pressed. Release the button to sew forward.
When the machine is stopped and foot control is
disconnected, the machine will sew in reverse slowly
as long as the reverse button is pressed. Release the
button to stop the machine.
• When any other stitches are selected:
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
stitches and automatically stop.
NOTE:
There will be particular functions of the reverse
button when stitch pattern U2, U3, B2, B13, or B14
is selected. Refer to pages 47, 62-63, 68 and 121 for
instructions.
(4) (5) (6)
(8)
Quilt Bridge Decorative
(3) Auto-lock button
• When the following stitch patterns are selected:
Utility Applique
Press the auto-lock button to sew a locking stitch
immediately. The machine will automatically stop.
When the machine is stopped, press the auto-lock
button and the LED signal (7) will blink. The machine
will immediately sew locking stitches and automatically
stop when the machine is started.
• When any other stitches are selected:
Press the auto-lock button to sew a locking stitch
at the end of current pattern. The machine will
automatically stop.
When the machine is stopped, press the auto-lock
button and the LED signal (7) will blink. The machine
will sew a locking stitch at the end of the current pattern
and automatically stop when the machine is started.
The machine will trim the threads automatically after
locking the stitch when the auto thread cutting is
turned on (refer to page 142).
(4) Needle up/down button
Press this button to bring the needle bar up or down.
The machine will stop with the needle in down position.
However, you can change the needle stop position in the
machine setting mode (refer to page 142).
(5) Presser foot lifter button
The presser foot will go up or down by pressing this
button.
You can also use the presser foot lifter and knee lifter to
raise and lower the presser foot (refer to pages 18 and
34).
(6) Thread cutter button
After finishing sewing, press this button to trim the
threads. The needle bar automatically rises after trimming
the threads (refer to page 42).
The LED signal (8) blinks when the machine trims
threads.
NOTE:
• The thread cutter button does not function:
- directly after turning on the power.
- when the presser foot is raised with the presser foot
lifter.
- after being pressed 3 times in a row.
• Use the thread cutter on the face plate if the thread
is #30 or thicker (refer to page 42).
After using auto thread cutting or threading the bobbin
holder, you can start sewing without drawing up the
bobbin thread.
16
Quilt Bridge Decorative